|
Surfaces
Session-31
*
What
is the use of surfaces?
*
Creating surface features
*
Open
and closed end surfaces
*
Creating flat surfaces
*
Creating offset surfaces
*
Creating a quilt by copy
Session-32
*
Creating advanced surface features
*
Creating surface by defining its boundaries
*
Blended surface
*
Conic
surface
*
Approximate blended surfaces
*
N
sided surfaces
Session-33
*
Working with quilts
*
Adding rounds on surface edges
*
Merging quilts
*
Trim,
Extend and Transforming the quilts
Session-34
*
Practice
Sheet metal
Session-35
*
Fundamentals of sheet metal
*
Wall
Creations (Flat, Extruded, Partial, Swept, Extend)
*
Twisted wall creation
Session-36
*
Cut
*
Rip
*
Punch
*
Notch
Session-37
*
Bend
*
Unbend
*
Bend
back features
Session-38
*
Form
features (die and punch)
*
Flatten form
*
Flat
pattern
*
Deformed area
*
Conversion from solid to sheet metal parts
*
Edge
bend operations
Session-39
*
Practice
Manufacturing
Session-40
*
Fundamentals of manufacturing
*
Creation of manufacturing model
*
Creation of manufacturing set up
*
Face
milling
Session-41
*
Profile milling
*
Pocketing
*
Trajectory milling
Session-42
*
Volume milling
*
Local
milling
*
Hole
making
Session-43
*
Conventional surface
*
Contour surface
*
Thread
*
Engraving
*
Plunge
Session-44
*
Lathe operations
*
Area, Profile, Groove, Trajectory, Thread and Hole making
Session-45
*
Practice
Mold
Design
Session-46
Mold Mode
*
Assembling a Workpiece
*
Adding Shrinkage
*
Automatic Workpiece
*
Parting Surface
*
Creating the Cavity and Core
Session-47
Mold Layout Mode
*
Cavity Layout
*
Adding a Mold Base
*
Cavity Pocket
*
Runner System
*
Ejector Pins
*
Waterlines
Session-48
Parting Line Applications
*
Saddle Shutoffs
*
Loop Selection
*
Slides
*
Splitting Volumes
*
Skirt Surface Options
Session-49
Custom Components
*
Slide Components
*
Sprue Bushing and Loc Ring
*
Mold Base Components
*
Adding Gates
Session-50
Part and Mold Analysis
*
Check Draft
*
Check Thickness
*
Creating a Molding Part
*
Opening the Mold
Session-51
*
Practice
Session-52, 53, 54
*
Project on Module-1 or Practice above modules from pdf files (notes)
ENGINEERS
CADD CENTRE PRIVATE LIMITED
F10, 11, 12
– Eureka Court, Beside BATA
Near
Chermas, Ameerpet
Hyderabad,
AP 500 073
INDIA
D. ANAND K.
REDDY, Managing Director, ECC
|
